Convert-Me.Com - online units conversion
Instant conversion pages: weight, length, volume, weight to volume, area, cooking, pressure, more...
converting degrees into inches
Forum rules
Dear convert-me.com forum visitors,
Our forum has been available for many years. In September 2014 we decided to switch it to read-only mode. Month after month we saw less posts with questions and answers from real people and more spam posts. We were spending more and more resources cleaning the spam until there were less them 1 legitimate message per 100 spam posts. Then we decided it's time to stop.
All the posts in the forum will be available and searchable. We understand there are a lot of useful information and we aren't going to remove anything. As for the new questions, you can always ask them on convert-me.com FaceBook page
Thank you for being with us and sorry for any inconveniences this could caused.
Dear convert-me.com forum visitors,
Our forum has been available for many years. In September 2014 we decided to switch it to read-only mode. Month after month we saw less posts with questions and answers from real people and more spam posts. We were spending more and more resources cleaning the spam until there were less them 1 legitimate message per 100 spam posts. Then we decided it's time to stop.
All the posts in the forum will be available and searchable. We understand there are a lot of useful information and we aren't going to remove anything. As for the new questions, you can always ask them on convert-me.com FaceBook page
Thank you for being with us and sorry for any inconveniences this could caused.
2 posts
• Page 1 of 1
converting degrees into inches
by edward1 » Sun Aug 09, 2009 4:44 am
If I were to move an object 4 degrees to the left, how many inches would that be??
- edward1
Re: converting degrees into inches
by Dirtman » Thu Aug 13, 2009 2:07 am
edward1 wrote:If I were to move an object 4 degrees to the left, how many inches would that be??
Assuming you want to know the distance 90º to the left of the original line, you need to know the radius (or distance from the central angle point to the point of departure).
IF the radius was 24", then: Tan(4º) * radius = 0.0699268 * 24" = 1.678"
- Dirtman
- Expert
- Posts: 574
- Joined: Sat Jan 21, 2006 2:04 pm
- Location: California
More info
2 posts
• Page 1 of 1