Convert-Me.Com - online units conversion
Instant conversion pages: weight, length, volume, weight to volume, area, cooking, pressure, more...
Grading Pipe
Forum rules
Dear convert-me.com forum visitors,
Our forum has been available for many years. In September 2014 we decided to switch it to read-only mode. Month after month we saw less posts with questions and answers from real people and more spam posts. We were spending more and more resources cleaning the spam until there were less them 1 legitimate message per 100 spam posts. Then we decided it's time to stop.
All the posts in the forum will be available and searchable. We understand there are a lot of useful information and we aren't going to remove anything. As for the new questions, you can always ask them on convert-me.com FaceBook page
Thank you for being with us and sorry for any inconveniences this could caused.
Dear convert-me.com forum visitors,
Our forum has been available for many years. In September 2014 we decided to switch it to read-only mode. Month after month we saw less posts with questions and answers from real people and more spam posts. We were spending more and more resources cleaning the spam until there were less them 1 legitimate message per 100 spam posts. Then we decided it's time to stop.
All the posts in the forum will be available and searchable. We understand there are a lot of useful information and we aren't going to remove anything. As for the new questions, you can always ask them on convert-me.com FaceBook page
Thank you for being with us and sorry for any inconveniences this could caused.
2 posts
• Page 1 of 1
Grading Pipe
by Trainee » Sun Jan 21, 2007 10:29 pm
Please help, I can't figure out how to figure out how much rise I'll have after laying one length of cement pipe. My pipe is 13 ft long, my invert is 3.66m, and my slope is .6%. So if I want to set up my grade stick, how much do I take off the invert to get .12%? How is this calculation done? I can get the pipe to the right start point but can't figure out how to set the grade stick for the laser? Help please.
- Trainee
Grading Pipe
by Trainee » Sun Jan 21, 2007 10:31 pm
Opps, I made a mistake. Change the .12% to .6 % . Sorry?
- Trainee
More info
2 posts
• Page 1 of 1