has any one, have any idea, what the building code measuring tolerance is, plus ( + ) mines ( - ) what ?? :?:
in gen.set back from property line, door ways,windows, and their location, walls, length and width of rooms.
Convert-Me.Com - online units conversion
Instant conversion pages: weight, length, volume, weight to volume, area, cooking, pressure, more...
contractor tolerance +/- ?rev.a.
Forum rules
Dear convert-me.com forum visitors,
Our forum has been available for many years. In September 2014 we decided to switch it to read-only mode. Month after month we saw less posts with questions and answers from real people and more spam posts. We were spending more and more resources cleaning the spam until there were less them 1 legitimate message per 100 spam posts. Then we decided it's time to stop.
All the posts in the forum will be available and searchable. We understand there are a lot of useful information and we aren't going to remove anything. As for the new questions, you can always ask them on convert-me.com FaceBook page
Thank you for being with us and sorry for any inconveniences this could caused.
Dear convert-me.com forum visitors,
Our forum has been available for many years. In September 2014 we decided to switch it to read-only mode. Month after month we saw less posts with questions and answers from real people and more spam posts. We were spending more and more resources cleaning the spam until there were less them 1 legitimate message per 100 spam posts. Then we decided it's time to stop.
All the posts in the forum will be available and searchable. We understand there are a lot of useful information and we aren't going to remove anything. As for the new questions, you can always ask them on convert-me.com FaceBook page
Thank you for being with us and sorry for any inconveniences this could caused.
2 posts
• Page 1 of 1
contractor tolerance +/- ?rev.a.
by falcon1933 » Thu Jan 21, 2010 8:01 pm
Last edited by falcon1933 on Sat Jan 23, 2010 7:02 pm, edited 2 times in total.
- falcon1933
- Posts: 10
- Joined: Sun Jan 03, 2010 12:57 am
Re: contractor tolerance +/- ?
by Dirtman » Sat Jan 23, 2010 3:40 am
falcon1933 wrote:has any one, have any idea, what the building code measuring tolerance is, plus ( + ) mines ( - ) what ?? :?:
More information is needed. It depends on which "Building Code" you're using and what aspect of a particular job you're referring to. Tolerances for handrails is vastly different from tolerances for grading.
- Dirtman
- Expert
- Posts: 574
- Joined: Sat Jan 21, 2006 2:04 pm
- Location: California
More info
2 posts
• Page 1 of 1