Convert-Me.Com - online units conversion
Instant conversion pages: weight, length, volume, weight to volume, area, cooking, pressure, more...
circumference to inches
Forum rules
Dear convert-me.com forum visitors,
Our forum has been available for many years. In September 2014 we decided to switch it to read-only mode. Month after month we saw less posts with questions and answers from real people and more spam posts. We were spending more and more resources cleaning the spam until there were less them 1 legitimate message per 100 spam posts. Then we decided it's time to stop.
All the posts in the forum will be available and searchable. We understand there are a lot of useful information and we aren't going to remove anything. As for the new questions, you can always ask them on convert-me.com FaceBook page
Thank you for being with us and sorry for any inconveniences this could caused.
Dear convert-me.com forum visitors,
Our forum has been available for many years. In September 2014 we decided to switch it to read-only mode. Month after month we saw less posts with questions and answers from real people and more spam posts. We were spending more and more resources cleaning the spam until there were less them 1 legitimate message per 100 spam posts. Then we decided it's time to stop.
All the posts in the forum will be available and searchable. We understand there are a lot of useful information and we aren't going to remove anything. As for the new questions, you can always ask them on convert-me.com FaceBook page
Thank you for being with us and sorry for any inconveniences this could caused.
2 posts
• Page 1 of 1
circumference to inches
by r wimble » Thu Mar 12, 2009 10:33 pm
i have a 10 foot round rug need to find linear inches of outer edge
- r wimble
Re: circumference to inches
by Dirtman » Fri Mar 13, 2009 8:32 am
r wimble wrote:i have a 10 foot round rug need to find linear inches of outer edge
Convert diameter in feet to diameter in inches: 10' x 12" = 120"
To obtain the circumference of a circle from the diameter, use the following formula:
PI x diameter
Where PI = 3.1416
- Dirtman
- Expert
- Posts: 574
- Joined: Sat Jan 21, 2006 2:04 pm
- Location: California
More info
2 posts
• Page 1 of 1