What's the formula to figure out the diameter of a circle if you know the acreage inside it?
A 100 square mile area (64000 acres) in a circular shape, would have what diameter?
A 50 square mile area (32000 acres) in a circular shape, would have what diameter?
Anyone know the formula to share with me?
Thanks,
ManFriday
Convert-Me.Com - online units conversion
Instant conversion pages: weight, length, volume, weight to volume, area, cooking, pressure, more...
formula needed
Forum rules
Dear convert-me.com forum visitors,
Our forum has been available for many years. In September 2014 we decided to switch it to read-only mode. Month after month we saw less posts with questions and answers from real people and more spam posts. We were spending more and more resources cleaning the spam until there were less them 1 legitimate message per 100 spam posts. Then we decided it's time to stop.
All the posts in the forum will be available and searchable. We understand there are a lot of useful information and we aren't going to remove anything. As for the new questions, you can always ask them on convert-me.com FaceBook page
Thank you for being with us and sorry for any inconveniences this could caused.
Dear convert-me.com forum visitors,
Our forum has been available for many years. In September 2014 we decided to switch it to read-only mode. Month after month we saw less posts with questions and answers from real people and more spam posts. We were spending more and more resources cleaning the spam until there were less them 1 legitimate message per 100 spam posts. Then we decided it's time to stop.
All the posts in the forum will be available and searchable. We understand there are a lot of useful information and we aren't going to remove anything. As for the new questions, you can always ask them on convert-me.com FaceBook page
Thank you for being with us and sorry for any inconveniences this could caused.
3 posts
• Page 1 of 1
formula needed
by manfriday » Thu May 10, 2007 6:54 am
- manfriday
- Posts: 2
- Joined: Thu May 10, 2007 5:49 am
More info
3 posts
• Page 1 of 1