Convert-Me.Com - online units conversion
Instant conversion pages: weight, length, volume, weight to volume, area, cooking, pressure, more...
Angle conversions
Forum rules
Dear convert-me.com forum visitors,
Our forum has been available for many years. In September 2014 we decided to switch it to read-only mode. Month after month we saw less posts with questions and answers from real people and more spam posts. We were spending more and more resources cleaning the spam until there were less them 1 legitimate message per 100 spam posts. Then we decided it's time to stop.
All the posts in the forum will be available and searchable. We understand there are a lot of useful information and we aren't going to remove anything. As for the new questions, you can always ask them on convert-me.com FaceBook page
Thank you for being with us and sorry for any inconveniences this could caused.
Dear convert-me.com forum visitors,
Our forum has been available for many years. In September 2014 we decided to switch it to read-only mode. Month after month we saw less posts with questions and answers from real people and more spam posts. We were spending more and more resources cleaning the spam until there were less them 1 legitimate message per 100 spam posts. Then we decided it's time to stop.
All the posts in the forum will be available and searchable. We understand there are a lot of useful information and we aren't going to remove anything. As for the new questions, you can always ask them on convert-me.com FaceBook page
Thank you for being with us and sorry for any inconveniences this could caused.
2 posts
• Page 1 of 1
Angle conversions
by Echase » Fri Aug 28, 2009 11:38 pm
You need a conversion from bearings to decimal degrees as well as rise over run. Eq. 18◦ 30’ converts to 18.5◦ as well as converting that to rise over run.
- Echase
Re: Angle conversions
by convert-me.com » Mon Aug 31, 2009 4:39 pm
Echase wrote:You need a conversion from bearings to decimal degrees as well as rise over run. Eq. 18◦ 30’ converts to 18.5◦ as well as converting that to rise over run.
Thank you for the suggestion, we'll think about it.
- convert-me.com
- Site Admin
- Posts: 402
- Joined: Fri Sep 05, 2003 4:50 pm
More info
2 posts
• Page 1 of 1