Hi,
Have a hydraulic pump with psi gauge. Trying to load a concrete beam at a load rate of 2.5kN/min.
How do I convert 2.5kN/min to psi?
Could you show working out please.
Convert-Me.Com - online units conversion
Instant conversion pages: weight, length, volume, weight to volume, area, cooking, pressure, more...
convert kN/min to psi... how?
Forum rules
Dear convert-me.com forum visitors,
Our forum has been available for many years. In September 2014 we decided to switch it to read-only mode. Month after month we saw less posts with questions and answers from real people and more spam posts. We were spending more and more resources cleaning the spam until there were less them 1 legitimate message per 100 spam posts. Then we decided it's time to stop.
All the posts in the forum will be available and searchable. We understand there are a lot of useful information and we aren't going to remove anything. As for the new questions, you can always ask them on convert-me.com FaceBook page
Thank you for being with us and sorry for any inconveniences this could caused.
Dear convert-me.com forum visitors,
Our forum has been available for many years. In September 2014 we decided to switch it to read-only mode. Month after month we saw less posts with questions and answers from real people and more spam posts. We were spending more and more resources cleaning the spam until there were less them 1 legitimate message per 100 spam posts. Then we decided it's time to stop.
All the posts in the forum will be available and searchable. We understand there are a lot of useful information and we aren't going to remove anything. As for the new questions, you can always ask them on convert-me.com FaceBook page
Thank you for being with us and sorry for any inconveniences this could caused.
3 posts
• Page 1 of 1
convert kN/min to psi... how?
by prolab » Sat Sep 22, 2007 7:13 am
- prolab
- Posts: 2
- Joined: Fri Sep 21, 2007 8:15 am
by prolab » Tue Sep 25, 2007 11:43 am
Anonymous wrote:It is still a pressure rate, and therefore psi/min.
(I assume you maintain this rate until you reach some maximum.) Apart from being a pressure rate, not just a pressure, the math looks correct.
Thats correct, I am maintaining this until failure occurs.
Thanks again!
- prolab
- Posts: 2
- Joined: Fri Sep 21, 2007 8:15 am
More info
3 posts
• Page 1 of 1