Hot Plastic

Forum rules
Dear convert-me.com forum visitors,

Our forum has been available for many years. In September 2014 we decided to switch it to read-only mode. Month after month we saw less posts with questions and answers from real people and more spam posts. We were spending more and more resources cleaning the spam until there were less them 1 legitimate message per 100 spam posts. Then we decided it's time to stop.

All the posts in the forum will be available and searchable. We understand there are a lot of useful information and we aren't going to remove anything. As for the new questions, you can always ask them on convert-me.com FaceBook page

Thank you for being with us and sorry for any inconveniences this could caused.

1 post • Page 1 of 1

Hot Plastic

by CJ » Sun Jun 24, 2007 4:14 am

I work with hot plastic on the roads.. we put down a 4" 120 mil line ....for old specs. I had to multiply LF by .31 then devide by 50 and that would tell me how many bags I should have used. .31 was for .90 mil..

But for the life of me I can't figure out for the 120 mil conversion... Ok, Lets say I put down 5280 feet of 4" line at 120 mil how many 50lb bags did I use?

Thanks for the help