Convert-Me.Com - online units conversion
Instant conversion pages: weight, length, volume, weight to volume, area, cooking, pressure, more...
kgf into Nm
Forum rules
Dear convert-me.com forum visitors,
Our forum has been available for many years. In September 2014 we decided to switch it to read-only mode. Month after month we saw less posts with questions and answers from real people and more spam posts. We were spending more and more resources cleaning the spam until there were less them 1 legitimate message per 100 spam posts. Then we decided it's time to stop.
All the posts in the forum will be available and searchable. We understand there are a lot of useful information and we aren't going to remove anything. As for the new questions, you can always ask them on convert-me.com FaceBook page
Thank you for being with us and sorry for any inconveniences this could caused.
Dear convert-me.com forum visitors,
Our forum has been available for many years. In September 2014 we decided to switch it to read-only mode. Month after month we saw less posts with questions and answers from real people and more spam posts. We were spending more and more resources cleaning the spam until there were less them 1 legitimate message per 100 spam posts. Then we decided it's time to stop.
All the posts in the forum will be available and searchable. We understand there are a lot of useful information and we aren't going to remove anything. As for the new questions, you can always ask them on convert-me.com FaceBook page
Thank you for being with us and sorry for any inconveniences this could caused.
2 posts
• Page 1 of 1
kgf into Nm
by dickavis » Fri Apr 14, 2006 7:38 pm
I've been told to tighten a set of bolt down to a certain pressure (measured in kgf which I know can be converted into N/mm squared). Of course my torque wrench is marked in Nm. I appreciate that one is a measurement of pressure and the other is torque and therefore the units are incompatable, but I assume that the calculation can be done. Do I need to take into consideration the size of bolt, whether or not the bolt has been greased, the length of my wrench, or any other details? Answers in words of one syllable please.
- dickavis
- Posts: 1
- Joined: Fri Apr 14, 2006 7:26 pm
by shill » Tue May 09, 2006 6:37 am
1 kgf is equal to 9.80665 N. Torque arising from a perpendicular force, in Nm, is calculated by multiplying the force, in N, by the distance of the force from the centre (roughly equivalent to the length of the wrench, if you are applying force near the tail end), in m.
- shill
- Expert
- Posts: 91
- Joined: Fri Feb 06, 2004 8:22 am
More info
2 posts
• Page 1 of 1