Convert-Me.Com - online units conversion
Instant conversion pages: weight, length, volume, weight to volume, area, cooking, pressure, more...
alignmet spec
Forum rules
Dear convert-me.com forum visitors,
Our forum has been available for many years. In September 2014 we decided to switch it to read-only mode. Month after month we saw less posts with questions and answers from real people and more spam posts. We were spending more and more resources cleaning the spam until there were less them 1 legitimate message per 100 spam posts. Then we decided it's time to stop.
All the posts in the forum will be available and searchable. We understand there are a lot of useful information and we aren't going to remove anything. As for the new questions, you can always ask them on convert-me.com FaceBook page
Thank you for being with us and sorry for any inconveniences this could caused.
Dear convert-me.com forum visitors,
Our forum has been available for many years. In September 2014 we decided to switch it to read-only mode. Month after month we saw less posts with questions and answers from real people and more spam posts. We were spending more and more resources cleaning the spam until there were less them 1 legitimate message per 100 spam posts. Then we decided it's time to stop.
All the posts in the forum will be available and searchable. We understand there are a lot of useful information and we aren't going to remove anything. As for the new questions, you can always ask them on convert-me.com FaceBook page
Thank you for being with us and sorry for any inconveniences this could caused.
2 posts
• Page 1 of 1
alignmet spec
by bill opalich » Thu Jun 18, 2009 1:40 am
My rear end alignmet spec from Nissan is for toe is in inched and our hunter alignmet rack gives us degrees how do I convert
- bill opalich
Re: alignmet spec
by Dirtman » Thu Jun 18, 2009 1:02 pm
bill opalich wrote:My rear end alignmet spec from Nissan is for toe is in inched and our hunter alignmet rack gives us degrees how do I convert
My suggestion is to call Hunter and ask for support, who could tell you exactly what you're needing to know. Converting inches to degrees is dependent on radius and I don't know what that would be. I'm surprised Nissan alignment specs would be in inches, I would expect mm or cm.
- Dirtman
- Expert
- Posts: 574
- Joined: Sat Jan 21, 2006 2:04 pm
- Location: California
More info
2 posts
• Page 1 of 1