Convert-Me.Com - online units conversion
Instant conversion pages: weight, length, volume, weight to volume, area, cooking, pressure, more...
how to convert gauge steel thickness
Forum rules
Dear convert-me.com forum visitors,
Our forum has been available for many years. In September 2014 we decided to switch it to read-only mode. Month after month we saw less posts with questions and answers from real people and more spam posts. We were spending more and more resources cleaning the spam until there were less them 1 legitimate message per 100 spam posts. Then we decided it's time to stop.
All the posts in the forum will be available and searchable. We understand there are a lot of useful information and we aren't going to remove anything. As for the new questions, you can always ask them on convert-me.com FaceBook page
Thank you for being with us and sorry for any inconveniences this could caused.
Dear convert-me.com forum visitors,
Our forum has been available for many years. In September 2014 we decided to switch it to read-only mode. Month after month we saw less posts with questions and answers from real people and more spam posts. We were spending more and more resources cleaning the spam until there were less them 1 legitimate message per 100 spam posts. Then we decided it's time to stop.
All the posts in the forum will be available and searchable. We understand there are a lot of useful information and we aren't going to remove anything. As for the new questions, you can always ask them on convert-me.com FaceBook page
Thank you for being with us and sorry for any inconveniences this could caused.
2 posts
• Page 1 of 1
- Guest
by Dirtman » Thu Sep 28, 2006 10:48 am
10 gage (gauge) carbon steel plate . . .
. . . is 5.625 lbs per square foot
. . . Manufacturers Standard Gage for Sheet Steel thickness in inches is 0.1345" (+/- 0.008). This is also known as Steel Gage.
This weight and thickness is only true for carbon steel sheets.
George
. . . is 5.625 lbs per square foot
. . . Manufacturers Standard Gage for Sheet Steel thickness in inches is 0.1345" (+/- 0.008). This is also known as Steel Gage.
This weight and thickness is only true for carbon steel sheets.
George
- Dirtman
- Expert
- Posts: 574
- Joined: Sat Jan 21, 2006 2:04 pm
- Location: California
More info
2 posts
• Page 1 of 1